Drag

Follow us

Trusted Industrial Metal Supplier Across PAN India

Duplex & Super Duplex Steel Products Manufacturer & Supplier in India

On-TimeDelivery
BulkSupply
60–70 TonnesReady Stock
Exporting to30+ Countries
Same-DayQuote
MTCAvailable

Amigo Impex manufactures and supplies products made of Duplex and Super Duplex materials. Duplex stainless steel holds roughly half its microstructure as ferrite and half as austenite, and the split is what gives the steel its strength and its corrosion behaviour. The dual-phase structure delivers about double the yield strength of a standard austenitic grade, with S32205 certified to SA-240 minima of 655 MPa tensile, 450 MPa yield and 25 per cent elongation, and it resists the chloride stress corrosion cracking that limits 300 series material, although it can still crack in hot chloride service above about 150 °C. Super Duplex pushes the chemistry further on chromium, molybdenum and nitrogen, which lifts pitting resistance and takes S32750 to 795 MPa tensile, 550 MPa yield and 15% elongation. The limit worth stating is heat: neither family is intended for continuous service much above 300 °C.

Heat is what destroys that phase balance. Heat input too high, or hot work outside the correct range, and brittle intermetallic phases settle through the ferrite and along the phase boundaries. Heat input too low, or cooling too fast, and austenite has no time to re-form, leaving excessive ferrite with poor toughness. Either way the ferrite to austenite ratio drifts, which quietly removes the corrosion resistance the grade was specified for. The certificate still reads 2205; the metal no longer behaves like it. We supply material in the solution annealed condition for that reason, and the cutting and fabrication we run in Mumbai are kept inside controlled heat input limits, with interpass temperature measured rather than assumed.

Our Duplex & Super Duplex Range

FAQ

Duplex & Super Duplex Steel FAQs

Find quick answers below. Still have a question? Our Mumbai team is always ready to help you further.

Amigo Impex facility

Yes, Duplex and Super Duplex are both Stainless Steels, classed apart from the austenitic and ferritic families because they carry the two phases together instead of one. Chromium runs from 22.0 to 23.0 per cent in S32205, with molybdenum at 3.0 to 3.5 and nitrogen at 0.14 to 0.20, and higher again in the 25Cr grades. That chromium is what makes them stainless in the first place.

The high yield strength and the work hardening of the dual-phase structure load a cutting edge far more heavily than an austenitic grade does, so speeds and feeds have to come down and tougher tool grades have to be used. Machining time should be quoted on that basis, because a job priced on austenitic cycle times will overrun.

Yes, carbon steel tooling, slings and racking can embed free iron in the surface, and that iron rusts and seeds pitting in service even where the metal underneath is sound. Keep handling and storage clear of carbon steel, and ask for pickling or passivation wherever a surface has been ground, plasma cut or welded.

Ready to Order?

Get a Quote on Duplex & Super Duplex

Send your size, condition and quantity. We confirm stock and lead time the same working day, with a mill test certificate on every order.